MODEL 3 Anderson Mfg. 5.56 x 45 mm NATO 16" Carbine Upper / Anderson Mfg. Forged Aluminum Lower With Magpul and UTG Accessories.
Available as shown in OD Green or all Black (30 round Magpul PMag magazine pictured, is not included)

 $685.00 + 30.00 S&H Shipped to your FFL Dealer
NO CREDIT CARD FEES!
 

Anderson Manufacturing AR15-A3 5.56mm Upper Receiver Features
100% made in the USA
7075T6 Aluminum
Mil-Spec Type III Hard Coat Anodized
National Match grade 1:8" Rifling
Chrome-Moly Barrels
5.56mm military chambers w/M4 feed ramps
Mil-Spec Bolt Carrier Group and Charging Handle

These Rifles Come with:

UTG Pro Made in USA Model 4 Carbine Length Tactical Quad Rails OD Green with rubber covers
UTG Tactical Low-Profile Universal Foldable Bipod
UTG Model 4/15 Match-Grade Rear Sight
Magpul CRT 6 Position Stock OD Green
Magpul MOE Pistol Grip OD Green
Magpul 30 ROUND P MAG MAGAZINE SHOWN IS NOT INCLUDED






UTG Pro Made in USA Model 4 Carbine Length Tactical Quad Rails OD Green with rubber covers




UTG Tactical Low-Profile Universal Foldable Bipod




Magpul Original Equipment Compact/TypeRestricted 6 position Srtock with rubber buttpad



Magpul Original Equipment (MOE Plus) Pistol Grip. Rubber overmold on polymer with storage core




UTG Model 4/15 Match-Grade Rear Sight



Anderson Manufacturing Forged Aluminum 5.56mm A3  Lower Receiver
100% made in the USA
7075T6 Aluminum
Mil-Spec Type III Hard Coat Anodized

AM15-lower-receiver-.jpg


A few words on ammunition and 16" carbines:

Our 556 NATO Carbines are test fired using PMC 223 Remington 55 grain FMJ-BT Ammunition. They are chambered for 556 but we test them with 223 to insure that the buffer system functions properly with the lower pressure round. We recommend that you use the same or comparable loads to insure proper cycling function and operation of your carbine. We do not recommend the use of any Russian, steel or lacquered cased ammunition with this rifle. Any other case material besides brass will result in chamber fouling and extraction problems.

Russian 556 NATO ammo is notorious for not cycling the action on carbines. We recommend that you do not fire any steel or lacquer cased ammo out of your new RGuns 16" carbine 556 MIL SPEC chambered upper receivers. Use only brass cased rounds. If you don't know how to tell the difference, steel is usually gray and lacquered is almost always green.

Our Carbines are test fired with magazine they have been shipped with, if ordered. If not we use a MIL SPEC 30 round aluminum magazine. We recommend using this magazine the first time out to insure proper operation, before using any other type of magazines such as Magpul PMags.

Before packing, the bore and chamber are scrubbed and swabbed. The Bolt Carrier Group is given a light coat of CLP inside and out.  Rem Oil is applied to the outside of the barrel. The rear sight, if included, is removed and packed separately due to shipping box constraints. Of course you should inspect the chamber and bore before use but It should function properly right out of the box.

After your first time out to the range, make sure to remove, disassemble and thoroughly clean the BCG. You will want to be sure to remove any carbon deposits from the bolt surface then lightly coat with CLP. This will help to prevent carbon buildup.

Note: Proper shouldering technique when firing 16" carbines is important for cycling. Make sure to keep good, firm pressure between the butt stock and your shoulder when firing. "Soft Shouldering" a carbine will more than likely cause it to "short stroke" and lock the bolt to the rear as it would when the last round has been fired and the magazine is empty.

All builds and components are covered by BST 100% as long as you own your rifle. If anything goes wrong with it we will repair or replace it at our expense - GUARANTEED

Cancellation / Return Policy - If you order a firearm, purchase by credit card and receive an order confirmation number from BST, then for whatever reason, decide to cancel your order before it has shipped, there will be a $35.00 restocking charge and a 6% refund processing service charge assessed against your payment amount before refund.

If your firearm has been delivered to your dealer and is not found to be defective upon receipt, it is considered to be non defective and serviceable. If you decide for any reason, that you would like to return a non defective and serviceable firearm to us for a refund, you have 10 days from the date of delivery to your dealer to do so, insured at your own expense for the purchase amount, plus $35.00 restocking charge as well as  a 6% refund processing service charge. After ten days we will not accept return of non defective and serviceable firearms for a refund.


If Black Star Tactical is not able to deliver your order for any reason, to include unforeseen ATF regulation changes implemented before your order has shipped,  we will refund your payment in full at no penalty. 

IF YOU HAVE ATTEMPTED TO BUY THIS RIFLE ON GUN SAMERICA PLEASE NOTE!
We do not handle any payment transactions through that site. The "Backup Buyer" and other functions do not work for purchasing our firearms.


TO ORDER THIS RIFLE
Call or email us at sales@black-star-tactical.com with your receiving dealer's zip code and your contact information. Let us know what you would like to order including any add on accessories. We will send you an itemized order confirmation including your order number, build specifications and actual shipping cost delivered to your FFL Dealer.
You can then contact us by phone with your credit card payment info to place your order.

812-744-5283

After your payment has cleared, we will email you an order number. You can contact your dealer after you have received your order number and have them email a scanned copy of their FFL to us at sales@black-star-tactical.com or snail mail to the above address.
Please have them include your name along with your order number as reference so that we can match up their ship to information with your order



Email Us at sales@black-star-tactical.com


BACK  HOME







Website counter